Root Welding With Wire Feeder - Optional; Constant Voltage Function - Helvi Maxitech 360C Manuel D'instructions

ROOT WELDING WITH WIRE FEEDER -
OPTIONAL
16 13 14 15
16B 16C 16D 16A
18 9 10
Figure 8 - Wire Feeder Control Panel - Copy
Selection Key
11
Selection of the 2Stroke / 4Stroke / Spot Welding
Mode / Pause-Work mode (P-W) (Spot LED blinking)
Selection Key
16A
for selecting the available welding parameters:
Current, - LED is lit
16B
Wire Speed,
16C
Thickness 0,6÷25 mm,
Left Display
16
for viewing the parameter selected with key - 16A -
9 Left Regulation Knob
Adjusts the parameter show in display - 16 -
Selection Key
17A
for selecting the available welding parameters:
Voltage, - LED is lit
17B
Arc Voltage Balance,
Operation Point,
Right Display
17
for viewing the parameter selected with key - 17A -
Right Regulation Knob
12
Adjusts the parameter show in display - 17 -
Dynamics
18 Setup Key -
Press key for regulation of the arc dynamics value
(-20% +20%) , use right regulation knob -
setting the parameters.
Save & Recall
19
for saving and recalling the points that the operator
can customize. Refer to the chapter "Save & Recall" .
17A 17B 17C 17D
11 12
- LED is lit
- LED is lit
16D
- LED is lit
17C
- LED is lit
17D
12 -

CONSTANT VOLTAGE FUNCTION

1
17
1
MODE
MATERIAL
6
Figure 7 - Power Source Control Panel - Copy
19
Figure 35 - Constant Voltage View
This function is suitable for the wire feeders powered
by the power source. Voltage must be adjusted on
the power source according to the welding wire type
and diameter, wire speed on the wire feeder.
for
7
2
1
/A /
V/PARAM.
SETUP
WORKING POINT
SAVE &
RECALL
DYN
8
5
2
4
EN-29