Mig Man Welding With Wire Feeder - Helvi Maxitech 360C Manuel D'instructions

Left Regulation Knob - Speed
7
Adjusts the wire speed regulation (1-25 m/min or
39-984 in/min)
Save & Recall
4
for saving and recalling the points that the operator
can customize. Refer to the chapter "Save & Recall".

MIG MAN WELDING WITH WIRE FEEDER

16C
16
18 9
Figure 8 - Wire Feeder Control Panel - Copy
Selection Key
11
Selection of the 2Stroke / 4Stroke / Spot Welding
Mode / Pause-Work mode (P-W) (Spot LED blinking)
Left Regulation Knob - Speed
9
for adjusting the wire speed regulation (1-25 m/min
or 39-984 in/min)
Left Display - Speed
16
for viewing wire speed in m/min or in/min,
LED is lit
12 Right Regulation Knob - Voltage
for adjusting the voltage ( 10V to 45V)
17 Right Display
for viewing the set voltage -
18 Inductance
Press key for regulation of the electronic inductance
value (0-30), use right regulation knob -
setting the parameters.
Low Value = colder arc High Value = hotter arc
19 Save & Recall
for saving and recalling the points that the operator
can customize. Refer to the chapter "Save & Recall" .
EN-20
17B 17
11 12 19
16C
- LED is lit
17B
for
12 -
-