Gouging; Gouging With Power Source; Gouging With Wire Feeder - Helvi Maxitech 360C Manuel D'instructions

In GOUGING process,connect the ground cable
on the negative (minus) -
gouging torch on the positive (plus) -
Connect torch with an external air compressor
Press Mode key to enter the gouging menu.
1
GOUGING WITH
POWER SOURCE
Welding current
Figure 18 - Gouging Display View
7
Left Regulation Knob - Current
Adjust the welding current (A) on a range from 50 to
the maximum current value.

GOUGING WITH WIRE FEEDER

Left Regulation Knob - Current
9
Adjust the welding current (A) on a range from 50 to
the maximum current value.
16
Left Display - Current
I2 Visualization in Amp
EN-16

GOUGING

- and connect the arc
E
-.
L
1
1 2
MODE
MATERIAL SETUP
DYN
Figure 7 - Power Source Control Panel - Copy
16
16B
18 9
Figure 8 - Wire Feeder Control Panel - Copy
7
1 2
/A /
V/PARAM.
WORKING POINT
SAVE &
RECALL
12
17
19