Tig Welding With Wire Feeder - Helvi Maxitech 360C Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Slope Up
Regulation of the time needed by the welding current
to reach the set value (0 – 10 Sec)
Down Slope
Regulation of the time needed by the welding current
to reach the final current value (Crater Filler 0 – 10
Sec)
Crater VAL
Regulation of the Final Current Value or Crater Filler
(5 till set current in A)
Post Gas
Regulation of the gas outflow time at the end of
welding (0 – 25 Sec.)
Use the Mode Key -
screen after parameters are adjusted.
Right Regulation Knob - Down Slope
5
Regulation of the time needed by the welding current
to reach the final current value (Crater Filler OFF /
0 – 10 Sec)
Navigation key
6 8
adjusts Post Gas value on a range from 0 to 25 sec
Left Regulation Knob - Current
7
adjusts the welding current (A) on a range from 5 to
maximum current value
Save & Recall
4
for saving and recalling the points that the operator
can customize. Refer to the chapter "Save & Recall".

TIG WELDING WITH WIRE FEEDER

16
16B
18
9
Figure 8 - Wire Feeder Control Panel - Copy
EN-18
- to go back to the TIG main
1
11
12
Left Regulation Knob - Current
9
adjusts the welding current (A) on a range from 5 to
maximum current value
Selection Key
11
Selection of the 2Stroke / 4Stroke
Right Regulation Knob - Down Slope
12
Regulation of the time needed by the welding current
to reach the final current value (Crater Filler OFF /
0 – 10 sec)
Left Display - Current
16
I2 Visualization in Amp,
Right Display - Down Slope
17
Down slope value in sec
Setup Key
18
Press Key 1 time for post gas setting, 2 time for v2
cut setting
Post Gas
Regulation of the gas outflow time at
the end of welding (0 – 25 Sec.)
V2 CUT
Arc voltage value over which the arc
switches off
Automatic - 16V to 44V - OFF
Save & Recall
19
for saving and recalling the points that the operator
can customize. Refer to the chapter "Save & Recall".
17
19
- I2 LED is lit
16B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Maxitech 500Maxitech 380Maxitech 355c

Table des Matières