Progress PHN1220 Notice D'utilisation page 26

26 progress
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Oven ceiling
You can remove the grill to clean the oven
ceiling more easily.
Warning! Deactivate the appliance
before you remove the grill. Make sure
that the appliance is cold. There is a
risk of burns.
1. Remove the screw which holds the grill.
For the first time, use a screwdriver.
2. Carefully pull the grill down.
3. Clean the oven ceiling with a soft cloth
with warm water and a cleaning agent,
and let it dry.
4. Install the grill in the opposite se-
quence.
Removing the oven door and the glass panel
Warning! Make sure that the grill is
correctly installed and that it does not
fall down.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of
electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or de-
activate the circuit breaker.
Put a cloth on the bottom of the oven
to prevent damage to the oven light
and glass cover.
1. Turn the glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an ap-
plicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two glass panels. You
can remove the oven door and the internal
glass panel to clean it.
The oven door can close if you try to
remove the internal glass panel before
you remove the oven door.
1. Open the door fully and hold the two
door hinges.