Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. SELECTING FUNCTIONS
To select the operating mode of the automation, press the corrisponding push-button:
ENTRY ONLY
The operator permits entry but not exit (the entry radar is active - the exit
radar is NOT active).
TWO WAY AUTOMATIC The operator permits both entry and exit (entry radar and exit radar are
both active).
EXIT ONLY
The operator permits exit but not entry (the exit radar is active - the entry
radar is NOT active).
DOOR OPEN
The door opens and remains in the open position (radar and/or photocells
NOT actives).
PARTIAL OPENING
The operator permits both entry and exit with reduced opening span (entry
radar and exit radar are both active).
DOOR CLOSED
The door closes and remains in
If an electro-lock is installed, the automation also is blocked.
By the combinationn of keys the following selections are also possible:
Keys
and
: MANUAL FUNCTIONING
Press simultaneously the keys
and
during some seconds and then release them.
It enters the "manual" function.
Now the key
allows to select the function "Pharmacie opening" and the key
"Man present".
note: other buttons will maintain their original function.
Keys
and
: BLOCK THE KEYBOARD
Press simultaneously the keys
and
for more than 3 seconds.
On display a message will be visualized:
TO BLOCK KEYBOARD?
YES
NO
To select Yes you have to press one of the three keys on the left:
Information
When the Keyboard block is enabled all the other keys are disabled and
it is impossible to operate any selection.
To reactivate the keyboard you have to repeat the procedure to visualize the message:
TO BLOCK KEYBOARD?
YES
NO
then select No by pressing one of the three keys on the right:
ENGLISH
closed.
selects the function
,
or
.
,
or
.
Keys
and
: RESET
The RESET allows to reset the equipment which is followed by a new cycle of initializing of the automation
EVO CONTROL.
Press simultaneously the keys
and
during more than 3 seconds.
On the display a message will be visualized:
RESET WING?
YES
NO
To select Yes push one of the three keys on the left:
In case you were entered in this procedure by error, to return to the normal functioning press one of
the three keys on the right:
,
or
.
Keys
and
: SOFTWARE VERSION
Press simultaneously the keys
and
during more than 3 seconds.
On display a message analogous to this will be visualized:
ITALIAN
T 1.0
W 1.1
The message visualize the selected language and the versions of installed software, respectively on the keyboard
programmer (T) and on EVO CONTROL (W).
Keys
and
: PARTIAL - TOTAL CYCLE COUNTER
Press simultaneously the keys
and
during more than 3 seconds.
On display the message will be visualized:
TOTAL
0
PARTIAL
00
The message visualize the total and the partial cycle counter. Only the partial cycle counter can be rezeroed.
To re-Zero the partial counter press the key
To exit this procedure to return to the normal functioning you have to press any other key.
The counters will be updated increasingly by 1 fi gure which will be visualized after every 10 completed cycles.
,
or
.
.
4 4
Publicité
Table des Matières
