Troubleshooting - Miller ICE-40C Manuel Du Propriétaire

6-5. Troubleshooting

Trouble
Power source Cup trouble light On; no
cutting output.
Sparks come out top of cut, or cut is not
clean.
Arc goes out while cutting.
Arc goes on and off while cutting.
Notes
OM-1593 Page 18
Tighten cup onto torch and reset Power (see Section 6-2).
Check torch connections on power source. See power source Owner's Manual.
Torch travel speed too fast; reduce travel speed (see Section 5-1).
Clean or replace worn consumables as necessary (see Section 6-3).
Metal being cut is too thick; increase output control setting. See power source Owner's Manual.
Be sure work clamp is securely attached. See power source Owner's Manual.
Make sure torch tip is contacting metal while cutting.
Be sure work clamp is securely attached. See power source Owner's Manual.
Clean or replace worn consumables as necessary (see Section 6-3).
Torch travel speed is too slow; increase travel speed (see Section 5-1).
Clean or replace worn consumables as necessary (see Section 6-3).
Be sure work clamp is securely attached. See power source Owner's Manual.
Remedy