Home Display; Start-Up Guide - Grundfos TPE2 Notice D'installation Et De Fonctionnement

15. Home display

1
Home
Setpoint
5.00 bar
Operating mode
Normal
9 8
Fig. 31 Example of Home display
Pos. Symbol Description
Home
This menu shows up to four
user-defined parameters. You can
1 select parameters shown as shortcut
icon
directly to the Settings display for the
selected parameter.
Status
This menu shows the status of the
2 -
pump and system as well as warnings
and alarms.
Settings
This menu gives access to all setting
parameters. You can make detailed
3 -
settings of the pump in this menu.
See section
functions.
Assist
This menu enables assisted pump
setup, provides a short description of
4 -
the control modes and offers fault
advice.
See section
Indicates that the pump has been
5
stopped via the
Indicates that the pump is functioning
6
as master pump in a multipump system.
Indicates that the pump is functioning
7 as a slave pump in a multipump
system.
Indicates that the pump is operating in
a multipump system. See section
8
17.51 "Multipump setup" (Setup of
multi-pump
Indicates that the possibility to make
settings has been disabled for
9 protective reasons. See section
17.35 "Buttons on product"
(Enable/disable
24
2 3 4
Status Settings Assist
Control mode
Const. pressure
Actual controlled value
4.90 bar
7 6 5
, and when pressing you go
17. Description of
17.47 Assist.
button.
system).
settings).

15.1 Start-up guide

The pump incorporates a startup guide which is started at the first
startup. See section 17.44 Run start-up
guide, the main menus appear in the display.
guide. After the startup