Building In - ETNA A1026VW Mode D'emploi

Building-in
1 . Make a hole in the side of the kitchen
cabinet to enable the gas pipe to be passed
through.
2 . Stick the strips of sealant to the underside of
the hob.
3 . Place the appliance in the cut-out.
4 . Secure the appliance in position.
5 . Make the gas connection. Check the gas
connections with a soap/water mixture
(see "Gas Connection").
securing the front and rear
6 . Put the plug in the socket
(see "Electrical Connection").
7 . Test to check the appliance is operational.
The building in of the hob in combination with
a built-in oven is described in the installation
guide for the oven.
Attention!
The underside of this built-in hob becomes
n
hot. Take care that you do not place any
flammable or plastic objects in any drawer
under the appliance.