Installation; General - ETNA A1026VW Mode D'emploi

General

The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
Please note:
This appliance is not connected to a flue duct.
Take care to ensure that there is sufficient
ventilation.
Electrical connection
230 V - 50 Hz.
This appliance complies the regulations
concerning electromagnetic compatibility in
directive 89/336/EEC.
The electrical connection must comply with
n
national and local regulations.
Wall socket and plug must be accessible at
n
all times.
If you want to make a fixed connection,
n
ensure that a multi-pole switch with a
distance between contacts of 3 mm is
installed in the supply cable.
Gas connection RC 1/2" (ISO 7/1-RC 1/2)
The gas connection must comply with
n
national and local regulations.
Amongst other things these regulations
instruct that:
– only approved materials are to be used;
– only a completely metal hose may be used
behind a built-in oven and beneath the hob.
Please note:
The type of gas and the country for which the
appliance has been designed are indicated on
the data badge.
We recommend that the hob be connected
n
by means of a fixed pipe. Connection using
a specially designed safety hose is also
permitted. In all cases the connection tap for
the appliance must be positioned such that
it is easily accessible, in an adjacent kitchen
cupboard, for example.
Please note:
A metal safety hose must not get kinks in it or
get trapped and must not come into contact with
moving parts of the kitchen furniture.
Before using the appliance for the first time
n
check the connections using water and
washing-up liquid to ensure that there are no
gas leaks.
Do not install a hob next to a high cupboard or
n
wall made of flammable material. (If there is
no alternative, ensure that there is a minimal
distance of 150 mm between the outer edge
of the hob and the wall in question. If there is
a wokburner, ensure that there is a minimum
distance of 750 mm between the hob and
overhead extractor fan.