Things To Watch For; Operating The Appliance; Lighting The Burners - ETNA A1026VW Mode D'emploi

Things to watch for

Clean immediately
Any spillage should be removed
n
immediately, particularly red cabbage,
apple sauce and rhubarb. These can leave
permanent spots on the enamel or on
stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
n
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly to ensure that the caps of
n
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.

Lighting the burners

While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match. The gas flame can now be
smoothly adjusted from high to low.
Electrical spark switch
Press the desired control knob and turn it
n
to the left to the maximum setting. Keep
the control knob depressed until the burner
ignites.
Thermocouple protection
This appliance is fitted with a thermocouple.
This is a thermoelectric protection system. It
ensures that the gas tap is closed if the flame
goes out.
P ress the desired control knob and turn
n
it to the left to the maximum setting. Hold
the control knob pressed in for 5 seconds.
Press the ignition until the burner ignites.
Burner cap
Burner ring
Spark plug
Thermocouple
Burner casing
Injector