Kemper 79 002 Mode D'emploi page 56

Art.- Nr.: 1502197
Fig. 5-11
● Install the exhaust hood (9) onto the free end of the
extraction arm (10). Position the plate springs (11) and brake
disc (12) as shown in Figure 5-11.
● Tighten the screws only so much that the exhaust hood
remains self-supporting in any position.
● Pull the tube end (13) over the sockets and tighten the
tube clamp (14).
● Cover the tube clamp, tube end and the gap between the
socket and rotary exhaust hood with the wide rubber ring (15).
Note
The ease of the joint is preset at the factory. If a readjustment
should be required, use only the screws in the hinge points
with plate springs. When properly adjusted, the position of the
extraction arm is held almost exclusively by the force of the
spiral springs.
Assembly
5-10