Labels And Signs To Be Posted By The Operator; Safety Instructions For The Operating Personnel - Kemper 79 002 Mode D'emploi

2.3 Labels and Signs to be posted by the Operator

2.4 Safety Instructions for the Operating Personnel

Art.- Nr.: 1502197
Safety
● The working and/or operating steps are indicated with a
bullet point. The steps must be performed in order from
top to bottom.
– The dash indicates an itemization.
Information, symbols, warning signs, operations signs and
component markings that are attached directly to the extraction
arm must be observed. It is not permitted to remove them and
they must remain clearly legible!
The operator is obliged, where appropriate, to post additional
labels and signs on the extraction arm and the surrounding
area.
Such labels and signs can, for example, pertain to the
requirement of wearing personal protective equipment.
The extraction arm shall be only used in technically perfect
condition and for the intended purpose in accordance with these
instructions! All errors and especially those that can impair safety
must be rectified immediately!
Each person who is charged with the commissioning, operation or
maintenance, must have fully read and understood this operating
manual - in particular Chapter 2 Safety. It would be too late to
read it during operation. This is applies particularly for personnel
who works on the extraction arm only occasionally.
The operating manual must be always at hand and close to the
extraction arm.
We do not accept responsibility for damages and accidents that
are caused by noncompliance with this operation manual.
The relevant accident prevention regulations and other generally
recognized safety and health rules and regulations must be
observed.
The responsibilities for different activities that pertain to
servicing and maintenance must be clearly specified and
followed. This is the only way that improper handling
- especially in dangerous situations - can be avoided.
2-2