Kemper 79 002 Mode D'emploi page 49

Fig. 5-3
Art.- Nr.: 1502197
● Place the seal (2) onto the slewing ring (3)
● Screw the slewing ring below the wall console
● Pull the rubber ring (4) over both halves of the slewing ring
Fig. 5-4
● Mount the support frame (5) in folded position onto the round steel
bar (6) of the rotatable sockets.
● Always use the bore holes (7) of the joint plate (8).
● Read on under Section "Continuation of all Mounting Methods".
Note
Only for extraction arms in tube version:
Shorten the rear part of the tube to 900 mm.
Assembly
5-3