Kemper 79 002 Mode D'emploi page 51

Art.- Nr.: 1502197
Fig. 5-6
● Mount the support frame (5) in folded position onto
the round steel bar (6) of the slewing ring.
● Position the round steel bar (6) between the joint plates (8)
● Insert two screws - M10 x 50 - 8.8 into the bore holes (7)
of the joint plates (8).
● Fix the mounting screws with nuts M 10
● Read on under Section "Continuation of all Mounting Methods".
Note
Only for extraction arms in tube version:
Shorten the rear part of the tube to 650 mm.
Assembly
5-5