Signature Kitchen Suite SKSDR480SIS Manuel Du Propriétaire page 92

92 LIMITED WARRANTY
Problem
• Surface is not level
• Oven is tipping
• Flames too big on
converted cooktop
(NP  LP)
• Flame is too small or
too large
Cause
1. Range not leveled
2. Anti-tip device not installed correctly
Anti-tip bracket
Screw must
Level both sides of range
enter wood or
concrete
Approximately
0.65"
(16.5 mm)
2
1
The installer missed part of the conversion.
(Check 2 parts: regulator, cooktop valve).
regulator cooktop valve
1. Variable gas pressure
2. Installer did not check
Center adjustment screw
• Check with installer first
Wall plate
Use carpenter's level to
check level.
• Check with installer first
• Refer to installation manual
• Check with installer first
Prevention