Cookware Placement; Moving Cookware On The Cooktop; Pan Sensing - Signature Kitchen Suite SKSDR480SIS Manuel Du Propriétaire

40 OPERATION

Cookware Placement

Use the proper cookware and place it correctly on
the cooktop. One or more of the cooking elements
will not heat if any of the incorrect conditions shown
is detected by the sensors located below the
ceramic cooktop surface. Correct the problem before
attempting to use the cooktop.
Correct
• Center cookware
on surface of
cooking element.
• Use pans with
flat bottom and
straight sides.
• Diameter of
pan is equal to
or larger than
cooking element.
• Pan rests
completely on
the cooktop
surface.
• Pan is properly
balanced.
Round Pan
Burner
(Diameter)
5 1/2" to 7"
Front
(14 to 18 cm)
5 1/2" to 7"
Rear
(14 to 18 cm)
7" to 8 11/16"
Flexible
(18 to 22 cm)
NOTE
• The sensor detects the diameter of the pan
based on the surface which is in actual contact
with the cooking element.
• The base of the cookware may be too small
for the burner even if the top opening is large
enough.

Moving Cookware on the Cooktop

Always use heavier gauge, high-quality cookware
on the cooking elements and do not slide it on the
ceramic cooktop surface. Even high-quality cookware
can scratch the cooktop surface.
• Always lift cookware before moving it on the
Incorrect
• Do not allow aluminum foil or any material that
Sliding any type of cookware over the surface will
scratch the cooktop over time. Scratches will make
cleaning the ceramic cooktop difficult and degrade
the appearance of the cooktop.
Rectangular Pan
(W x L)

Pan Sensing

7" X 8 11/16"
(18 X 22 cm)
The cooking-element sensors located below the
7" X 8 11/16" cooktop surface require certain cookware conditions
(18 X 22 cm) to be met before the induction cooking elements can
operate.
14 3/16" X 8 11/16"
The cooking zone LED bar may display a pan sensing
(36 X 22 cm)
error message. If a cooking element is activated
and no cookware is detected, the affected induction
cooking zone LED bar will fluctuate. If the cookware
does not meet the correct conditions, the cooking
zone may not heat.
If the problem is not corrected, the affected cooking
element will automatically deactivate within 30
seconds.
NOTE
ceramic glass surface. Any cookware that has
a rough or dirty bottom can mark and scratch
the cooktop surface. Always start with clean
cookware.
can melt to make contact with the ceramic glass
cooktop. If these materials melt on the cooktop
they may damage the ceramic glass surface.