Cleaning And Maintenance - Dometic SKYSCREEN POWERED Instructions De Montage Et De Service

Cleaning and maintenance

• Only if operated by switches: When operating the blind with switches
each switch operates each blind independently.
• Only if operated with the AP Remote control: When operating the blind
with the AP Remote control each blind is independently operated via sepa-
rate channels on the remote control.
• Each blind can be stopped in any position.
• When operating the blind with an automation system, the operation is
dependent on the programming of the control interface.
• The blind automatically stops
– when the blind is fully deployed,
– when the blind is fully stowed
– if the blind hits an obstruction (including the other moving rail)
9 Cleaning and maintenance
A
NOTICE! Risk of damage
• Do not grease, oil or lubricate the blind. Lubricants will damage the fabric.
• Be careful not to crease the fabric when using the brush attachment of a
vacuum cleaner.
• Rubbing can damage fabrics. Do not scrub.
• Spot-cleaning may result in cleaner areas than the surrounding.
• Do not soak the blinds.
• The manufacturer recommends testing any cleaning agents on a hidden
area of the blind first.
I
NOTE Cleaning by professional cleaning personnel
The manufacturer cannot be held liable for improper cleaning methods or
agents used by professional cleaning personnel. In this case the responsibility
lies with the cleaning company.
Removing dust
➤ Dust the blind regularly with a dust rag, dust glove or a vacuum cleaner with
a brush attachment. Blow excess dust off of your fabric using a can of com-
pressed air or a hair dryer on a cool setting.
➤ Fully deploy the blind to clean the fabric.
➤ Fully stow the blind to clean around the frame.
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water. Add a mild
detergent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
18
Skyscreen Powered
EN