Suspensions Settings According To The Weight Of The Rider; Static Sag Load Test - Beta Motorcycles RR 125 2T EUROPA 2019 Mode D'emploi

3

SUSPENSIONS SETTINGS ACCORDING TO THE WEIGHT OF THE RIDER

The table below shows the spring constant K of the suspensions (fork and shock
absorber) depending on the weight of the driver.
Refer to the accessories catalogue Betamotor to obtain the spring codes.
Standard settings
EN
H
Rider weight [kg]
70 - 85
85 - 95
95 - 105
>105
Shock absorber
Rider weight [kg]
70 - 85
85 - 95
95 - 105
>105

STATIC SAG LOAD TEST

To verify the static sag of the shock ab-
sorber proceed as follows:
H
1
- Place the motorcycle on the work stand.
- Measure the vertical distance between
the rear wheel axle and a reference point
on the rear fairings.
- Write down the dimension H
- Remove the work stand.
- Keep the motorcycle in vertical position
and measure again the distance between
the wheel axle and the reference point
previously established.
- Write down the dimension H
2
Verify that the value of the static compres-
sion X = H
1
on page 11. Otherwise, perform the
adjustment of the spring preload as de-
scribed above.
Fork
46
.
1
2
- H matches the one shown
2
K (Spring constant)
3,9
4,2
4,6
4,8
K (Spring constant)
4,8
5,0
5,2
5,4
.