Shock Absorber; Adjusting The Spring Preload; Adjusting The Rebound Damper; Adjusting The Compression Damper - Beta Motorcycles RR 125 2T EUROPA 2019 Mode D'emploi

3

ADJUSTING THE SPRING PRELOAD

The spring preload is adjusted by using the
ring nut B. Rotate clockwise to increase
the spring preload or anticlockwise to
decrease it.
B
The spring preload varies by one millim-
eter, each complete revolution.
For standard calibration, refer to page 11.
ADJUSTING THE COMPRESSION
DAMPER
The hydraulic compression damper deter-
C
mines the behaviour of the telescopic fork
during compression and can be adjusted
by means of knob C located at the lower
end of the fork legs. Turning the screw
clockwise (towards +) increases the ac-
tion of the compression damper; turning
it anticlockwise (towards -) decreases the
action of the compression damper.
For standard calibration, refer to page 11.

SHOCK ABSORBER

ADJUSTING THE REBOUND
DAMPER
Turn screw A to adjust the hydraulic re-
bound damper.
A
Turning the screw anticlockwise (out) de-
creases the damping effect.
For standard setting, refer to page 11.
EN
44