Spark Plug; Air Filter Cleaning - Rr 125 Europe; Air Filter Cleaning - Rr 125 - Beta Motorcycles RR 125 2T EUROPA 2019 Mode D'emploi

AIR FILTER CLEANING - RR 125 EUROPE

Blow the filter with compressed air.

AIR FILTER CLEANING - RR 125

• Thoroughly wash the filter with water and soap.
• Dry the filter.
• Wet the filter with filter oil and then remove the excess oil to prevent it from drip-
ping.

SPARK PLUG

Keeping the spark plug in good condition will reduce fuel consumption and increase
engine performance.
To accede to spark plug, is necessary to take off the fuel tank with side fairings
(page 83).
To perform the check, just extract the spark plug cap and unscrew the spark plug by
means of the provided wrench.
Carefully clean the electrodes using a wire brush. Blow the spark plug with com-
pressed air to prevent any residues from getting into the engine.
Examine the distance between the elec-
trodes with a feeler. This distance should
be from 0,5 - 0,7 mm. If it is not, it may be
corrected by bending the earth electrode.
The spark plug may appear:
black "fat" carburation
light brown appropriate carburation
white "thin" carburation
Check as well that there are no cracks in
the insulation or corroded electrodes. If so,
replace immediately.
Lubricate the spark plug thread, and then
(when the engine is cold) screw in the spark
plug by hand to its abutting end. Finally
tighten the spark plug with the spanner.
WARNING:
Do not check while the engine is hot.
55
4
0,5÷0,7
EN