Operation Modes And Speed Settings; Switching On/Off And Selecting An Operation Mode; Selecting A Speed Setting; Starting And Ending The Treatment - Silk-n BRIGHT ND-FC04 Mode D'emploi

6.2 Operation modes and speed settings

The facial brush is equipped with a vibrating and a pulsating mode.
• The vibrating mode uses uniform vibrations for deep, gentle
cleansing.
• The pulsating mode uses alternating strong and weak
vibrations for a massage-like soothing effect.
• The "Bright" version has 7 speed settings for each mode.

6.3 Switching on/off and selecting an operation mode

1. Press the control button ( )
switched on and in the vibrating mode.
You will hear one beep sound when the facial brush is
switched on.
2. Press the control button ( ) again. The facial brush is now in
the pulsating mode.
3. Press the control button ( ) a third time to switch off the
facial brush.
You will hear two beep sounds when the facial brush is
switched off.

6.4 Selecting a speed setting

1. Select an operation mode (see chapter "Switching on/off and
selecting an operation mode").
2. Press the increase button ( )
in the selected operation mode to select a speed setting (1–7).
The default level is 4.

6.5 Starting and ending the treatment

• You may start your treatment after selecting an operation
mode and a speed setting.
• Once the facial brush starts, you will hear a beep sound every
30 seconds, hinting you about the time that has passed. The
facial brush will automatically switch off after 2 minutes. Please
note that whenever you change the operation mode or speed
setting during treatment, the timer will be reset to zero.
• You can also end the treatment anytime by pressing the
control button ( )
more than once, depending on the product version and
current operation mode.
once. The facial brush is now
6
or decrease button ( )
5
. You may have to press the button
6
EN
7
14