Intended Use - Fronius TTB 80 G Instructions De Service

Danger from contact with toxic welding fumes.
Serious personal injuries may result.
▶
▶
▶
Danger from operation without coolant.
This can result in damage to property.
▶
▶
▶

Intended use

The TIG manual welding torch is intended solely for TIG welding and TIG brazing in ma-
nual applications.
Any other use is deemed to be "not in accordance with the intended purpose." The ma-
nufacturer shall not be liable for any damage resulting from such improper use.
Intended use also means:
-
-
WARNING!
Welding is not permitted without an extraction unit being switched on.
It may not be sufficient to only use a fume extraction torch to reduce the concentrati-
on of noxious substances at the work station. In this case, install an additional ex-
traction system to properly reduce the concentration of noxious substances at the
work station.
In case of doubt, the concentration of noxious substances at the work station should
be assessed by a safety engineer.
CAUTION!
Never operate water-cooled welding torches without coolant.
During welding, ensure that the coolant is circulating correctly – this will be the case
for Fronius cooling units if a regular return flow of coolant can be seen in the coolant
container of the cooling unit.
The manufacturer will not be liable for any damages due to non-observance of the
above mentioned points. All claims against the warranty are void.
Following all the instructions in the Operating Instructions
Carrying out all the specified inspection and maintenance work.
55