Fronius TTB 80 G Instructions De Service page 71

Open the protective bag:
3
- Push both zip pulls to the right as far as they will go
- Pull the bottom end of the tape out of the zip pulls
Place the interface connecting the extension hosepack and the torch hosepack in
4
the inside pocket of the protective bag
5
A
- * = Velcro strips on the inside pocket (inside pocket not shown)
- Secure the interface in the inside pocket with 2 Velcro strips
6
A
1
1
1
- Route the coolant hose from the extension hosepack (A) to the interface as shown
- Wrap the coolant hose from the torch hosepack (B) around the torch hosepack 3
times and route to the interface
- Connect the coolant hoses
1
B
2
2x
B
2
71