Cisco 1250 Série Guide De Démarrage Rapide page 25

Connecting to an Ethernet Network with an Inline Power
Source
Caution
Be careful when handling the access point; the bottom plate
might be hot.
Note If your access point is connected to in-line power, do not connect the
power module to the access point. Using two power sources on the
access point might cause the access point to shut down to protect
internal components and might cause the switch to shut down the
port to which the access point is connected. If your access point
shuts down, you must remove all power and reconnect only a single
power source.
Follow these steps to connect the access point to the Ethernet LAN when you
have an inline power source:
Step 1
Connect a Category 5E (or higher) Ethernet cable to the RJ-45
Ethernet connector labeled Ethernet on the access point.
Step 2 Step 2 Connect the other end of the Ethernet cable to one of the
following:
Quick Start Guide: Cisco Aironet 1250 Series Access Point
25