Cisco 1250 Série Guide De Démarrage Rapide page 20

Note
If your access point is connected to in-line power, do not connect the
power module to the access point. Using two power sources on the
access point might cause the access point to shut down to protect
internal components and might cause the switch to shut down the
port to which the access point is connected. If your access point
shuts down, you must remove all power and reconnect only a single
power source.
Obtaining and Assigning an IP Address
To browse to the access point Express Setup page, you must either obtain or
assign the access point IP address using these methods:
• Assign a static IP address by connecting to its console port and opening
the access point CLI.
• Use a DHCP server (if available) to automatically assign an IP address.
You can find out the DHCP-assigned IP address by using one of the
following methods:
– Connect to the access point console port and use a Cisco IOS
command such as show interface bvi1 to display the IP address.
20
78-17831-01B0