Cisco 1250 Série Guide De Démarrage Rapide page 21

– Provide your organization's network administrator with your access
point MAC address. Your network administrator will query the
DHCP server using the MAC address to identify the IP address. The
MAC address is on a label attached to the bottom of the access
point.
– Use the CLI and serial port to identify the assigned IP address.
Connecting to the Access Point Locally
If you need to configure the access point locally (without connecting it to a
wired LAN), you can connect a PC to its console port by using a DB-9 to
RJ-45 serial cable.
Follow these steps to open the CLI by connecting to the access point console
port.
Step 1
Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45
console port on the access point and to the COM port on the PC.
Step 2
Set up a terminal emulator on your PC to communicate with the
access point. Use the following settings for the terminal emulator
connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow
control.
Quick Start Guide: Cisco Aironet 1250 Series Access Point
21