Using The Mode Button - Cisco 1250 Série Guide De Démarrage Rapide

If you forget the password that allows you to configure the access point, you
may need to completely reset the configuration. You can use the MODE
button on the access point or your web browser to reset the configuration.

Using the MODE Button

Follow these steps to delete the current configuration and return all access
point settings to the factory defaults:
Step 1
If the access point is mounted using its mounting plate, remove it to
gain access to the MODE button.
Step 2
Disconnect power from the access point (the power jack for external
power or the Ethernet cable for in-line power).
Step 3
Press and hold the MODE button while you reconnect power to the
access point.
Step 4 Continue holding the MODE button until the Ethernet LED turns
amber (approximately 2 to 3 seconds), then release the button.
Step 5
After the access point reboots, you must reconfigure it using the
web browser interface, the Telnet interface, or connecting to the
access point console port.
Quick Start Guide: Cisco Aironet 1250 Series Access Point
33