E-Mail - Speck pumpen BADU Genio Traduction Des Instructions D'utilisation D'origine

Operation

7.18 E-mail

The e-mail message function can be found in the settings under
Service. Here, the error/fault messages displayed in the events
are sent. The control system must be permanently connected to
the RJ45 interface by a network cable (Internet access must be
available).
There are three different modes of operation:
• On: Function is active
• Off: Function is deactivated
• Test Mail: A test e-mail is sent
• Recipient: Several recipients possible. Enter separated by
commas.
• Free text: Free text input for identification by the operator
58 EN 09|2019