CORRECT WORKING WITH THE PLUNGE
SAW
• Always hold the plunge saw with both
hands at the handles (3) and (15).
• Always guide the plunge saw forward.
Never draw the plunge saw back!
• Place the plunge saw with the front part of
the base plate (5) on the work piece. Guide
the plunge saw only against the work piece
during operation.
• With the correct forward speed you prevent
overheating of the saw blade, and melting
when cutting plastics.
STRAIGHT CUTS (90° CUT)
1. Loosen both rotary knobs (10) and swivel
the saw to 0° position on the scale. Tighten
the rotary knobs again.
2. Turn the selector switch (20) to plunge cut
function.
3. Set the desired plunge depth. Ensure that
the guide rail track compensation (12) is up
when using the saw without guide rail.
4. To switch on the saw press the switch lock
(1) and the ON/OFF switch (2) and push
the motor down. Guide the saw forward to
cut.
MITER CUTS (UP TO 48°)
1. First loosen both rotary knobs (10) and
swivel the plunge saw to the desired
graduation. Tighten the rotary knobs again.
2. Switch the plunge saw on.
3. Turn the selector switch (20) to plunge cut
function.
28
7062938-T-Raxx-1400W-Ma-1801-23.indd 28
4. Set the desired plunge depth. Ensure that
the guide rail track compensation (12) is in
up position when using the saw without
guide rail.
5. To switch the saw on press the switch lock
(1) and the ON/OFF switch (2) and push
the motor down. Guide the saw forward to
cut.
The cutting indicator (17) shows the cutting
path for 90° and 45° miter cuts (without using
the guide rail).
MARKED CUTTING
1. Turn the selector switch (20) to marked cut
function.
2. Press the switch lock (1) and push the
motor down. The casing stops in 2.0 mm
cutting depth position.
Note: The marking line should be aligned
with cutting line
A
(0 mark).
05-03-18 10:16