Guide Rail And Clamps - Batavia T-RAXX BT–PS008 Mode D'emploi

Saw blade
Outer
flange
Screw
6. Use the Allen key to loosen the screw
counter-clockwise. Remove the outer
flange and the saw blade.
7. Clean both flanges and replace the saw
blade.
Note: The rotation direction arrows of saw
blade and saw must be aligned!
8. Replace the outer flange in such way that
the slaving pins sit in the recesses of the
inner flange.
9. Press and hold the shaft lock and tighten
the screw. Press the switch lock (1) for the
casing to swivel up again.
GUIDE RAIL(S) AND CLAMPS
(OPTIONAL)
The guide rails allow precise and clean
straight cuts, miter cuts and fitting. The rails
also protect the work piece surface from
damages.
Fixing with the clamps ensures solid grip and
safe work.
1. Unlock the clamps by pressing the unlock
buttons. Open the clamps according to the
thickness of the work piece.
2. Place the guide rail on the work piece and
30
7062938-T-Raxx-1400W-Ma-1801-23.indd 30
fix the guide rail with the clamps. Slide the
bar into the groove of the guide rail and
tighten the clamp with the lever.
Note: Place the guide rail with the black
foam strips on the work piece.
Inner flange
3. Place the plunge saw on the guide rail. The
base plate has a groove (16), which exactly
fits into the guide ridge of the rail.
Guide ridge
4. Guide the plunge saw from the edge of the
guide rail and pull the guide rail lock (7)
upwards and turn it towards I to connect the
Bar
Unlock button
05-03-18 10:16