Preparation; Correct Working With The Plunge Saw; Straight Cuts (90° Cut); Miter Cuts (Up To 48°) - Batavia T-Raxx BT-PS002 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

cutting line when using the plunge saw
without guide rail for straight cuts.
2. For 45° miter cuts align position
on base plate) at the front of the base plate
with your marked cutting line.

PREPARATION

• Before each use check the proper function
of all installation fixtures of the plunge saw
and only use the plunge saw if everything
works properly.
• Attach the work piece in such way that it
cannot move or bend during work. Line the
work piece respectively.
CORRECT WORKING WITH THE PLUNGE
SAW
• Always hold the plunge saw with both
hands at the hand grips (3) and (13).
• Always guide the plunge saw forward.
Never draw the plunge saw back!
• Place the plunge saw with the front part of
the base plate (4) on the work piece. Guide
the plunge saw only against the work piece
during operation.
• With the correct forward speed you prevent
overheating of the saw blade, and melting
when cutting plastics.
26
7061494-T-Raxx_1200W-Ma-1805-17.indd 26
STRAIGHT CUTS (90° CUT)
1. Loosen both rotary knobs (8) and swivel the
saw to 0° position on the scale. Tighten the
rotary knobs again.
2. Turn the selector switch (18) to plunge cut
function.
3. Set the desired plunge depth. Ensure that
the guide rail track compensation (10) is up
B
(45 mark
when using the saw without guide rail.
4. To switch on the saw press the switch lock
(1) and the ON/OFF switch (2) and push
the motor down. Guide the saw forward to
cut.
MITER CUTS (UP TO 48°)
1. First loosen both rotary knobs (8) and
swivel the plunge saw to the desired
graduation. Tighten the rotary knobs again.
2. Switch the plunge saw on.
3. Turn the selector switch (18) to plunge cut
function.
4. Set the desired plunge depth. Ensure that
the guide rail track compensation (10) is in
up position when using the saw without
guide rail.
5. To switch the saw on press the switch lock
(1) and the ON/OFF switch (2) and push
the motor down. Guide the saw forward to
cut.
The cut indicator (15) shows the cutting path
for 90° and 45° miter cuts (without using the
guide rail).
17-05-18 10:30

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7061494

Table des Matières