Plunge Cuts; Change Saw Blade - Batavia T-RAXX BT–PS008 Mode D'emploi

PLUNGE CUTS

1. For a straight cut first loosen both rotary
knobs (10) and swivel the plunge saw to 0°
position on the scale. Tighten the rotary
knobs again.
2. Turn the selector switch (20) to plunge cut
function.
3. Set the desired plunge depth. Ensure that
the guide rail track compensation (12) is up
if not using the guide rail.
4. Press the switch lock (1) and the ON/OFF
switch (2) and push the motor down. Guide
the saw forward to cut.
Note: To prevent the saw from kicking back
during plunge cuts follow these steps:
• Always place the plunge saw with the rear
edge of the base plate (5) against a fixed
limit stop.
• Hold the plunge saw in both hands and
slowly lower the saw blade.
• The cutting width marks (18) show the most
foremost and rearmost cutting points of the
saw blade (Ø 165 mm) at maximum cutting
depth and when using the guide rail.

CHANGE SAW BLADE

Before any maintenance work always switch
off the plunge saw and disconnect from mains
power!
1. Loosen both rotary knobs (10) and swivel
the plunge saw to 0° position before
changing the saw blade. Tighten the rotary
knobs again.
2. Set the selector switch (20) to the change
saw blade icon.
7062938-T-Raxx-1400W-Ma-1801-23.indd 29
3. Press the switch lock (1) down and push
the motor down.
4. Press and hold the shaft lock down.
5. Use a 5 mm Allen key to turn the screw at
the saw blade slightly clockwise or counter-
clockwise until the spindle clicks into place.
EN
29
05-03-18 10:16