Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(11) and slide it to the desired cutting depth
according to the graduated scale (13) to set
the cutting depth.
Note: The graduated values on the scale
(13) apply for straight cuts (90° cut).
The guide rail track compensation (12)
must be tilted up when using the plunge
saw without guide rail. Only when using
the plunge saw with guide rail the guide rail
track compensation is used to compensate
for the thickness of the guide rail.
Using the guide rail = guide rail track
compensation down.
Not using the guide rail = guide rail track
compensation lever up.
2. Tighten the cutting depth limit stop knob
(11). The motor or respectively the saw
blade can now be pushed down to the set
cutting depth.
For a clean, safe cut set the cutting depth in
such way that only max. one saw blade
tooth protrudes under the work piece.
SET CUTTING ANGLE
The plunge saw can be swiveled between 0°
and 48°:
1. Loosen both rotary knobs (10). Swivel the
7062938-T-Raxx-1400W-Ma-1801-23.indd 27
motor to the desired cutting angle on the
cutting angle scale.
2. Tighten the rotary knobs (10) again.
DETERMINE CUTTING LINE
Two cutting lines are marked on the base plate
(5) of the plunge saw.
1. Align position
A
(0 mark on base plate) at
the front of the base plate with your marked
cutting line when using the plunge saw
without guide rail for straight cuts.
2. For 45° miter cuts align position
on base plate) at the front of the base plate
with your marked cutting line.
PREPARATION
• Before each use check the proper function
of all installation fixtures of the plunge saw
and only use the plunge saw if everything
works properly.
• Attach the work piece in such way that it
cannot move or bend during work. Line the
work piece respectively.
EN
B
(45 mark
27
05-03-18 10:16
Publicité
Table des Matières
