Installation And Setup; Installation Process - Franklin Electric SUBDRIVE UTILITY Manuel D'utilisation

INSTALLATION AND SETUP

Installation Process

Refer to the following table when planning installation of the SubDrive Utility.
1
Plan System
Goals
Intended Function
• Constant
pressure water
systems
• Pressure
Boosting
Hardware
Application
• Submersible
• Surface pump
1. The planned usage of the overall system will determine which options and control methods
are appropriate, as well as how the VFD should be installed and programmed. Refer to the fol-
lowing pages for examples of how the system might be used.
2. System options define and automate features that support the intended operation. These fea-
tures may require specialized control methods and programming. For more details, refer to
"Drive Configuration" on page
3. The SubDrive Utility supports several methods for automating pump motor speed control.
Refer to "Drive Configuration" on page 24
4. The overall function of the system directly affects where and how the VFD should be mounted.
Refer to "Physical Installation" on page 16
5. The selected motor application, along with the control method(s), determines how the VFD
should be connected. Refer to
6. The VFD can be quickly and easily programmed for most standard operations. Refer to
Configuration" on page
to achieve the desired performance. Refer to
2
Identify Select Control
Options Methods
Automation Pressure Feed-
back Type
• Bump mode
• Steady Flow • Transducer
• Drawdown • Pressure Sensor
Protection Potentiometer
• Overload • Setpoint value
• Underload • Underload
• Motor Ground Sensitivity
Fault
• Drive
Temperature
24, and "Performance Settings" on page
for guidelines.
"Electrical Installation" on page 18
24. Advanced features or options may require additional adjustments
3 4
Install VFD
Hardware
Location
• Inside
• Outside
Climate control
• Temperature
• Moisture
Distance
• Wire sizes
• Filtering
requirements
Measurements
• Clearance
• Drilling
for possible control setups.
for more information.
"Performance Settings" on page
INSTALLATION AND SETUP
Installation Process
5
Install Wiring Program
Parameters
Conduit Basic
• Routing • Application
• Separation • Motor ratings
• Setpoints
High Voltage
I/O setup
• Grounding
• Inputs • Input functions
• Outputs
Option settings
Control circuits
• Enable features
• Feedback
inputs
27.
"Drive
27.
6
11