Checks After Starting Engine; Cooling Water - Yamaha F75 Manuel De L'utilisateur

Operation
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3. Turn the main switch to "
TIP:
Dual engine users: When the main switch is
turned on, the buzzer operates for a few sec-
onds then stops automatically. The buzzer
also operates if one of the engines stalls.
4. Turn the main switch to "
and hold it for a maximum of 5 seconds.
60
5.
ZMU01772
" (on).
EMU36511

Checks after starting engine

EMU36524

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
ECM01811
" (start),
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check whether
ON
OFF
Immediately after the engine starts, re-
lease the main switch to return it to "
(on). NOTICE: Never turn the main
switch to " " (start) while the en-
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 seconds,
the battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
aged. If the engine will not start after 5
seconds of cranking, return the main
switch to " " (on), wait 10 seconds,
then crank the engine again.
START
ZMU01881
"
[ECM00193]