Main Switch; Steering Friction Adjuster; Power Trim And Tilt Switch On Remote Control Or Tiller Handle - Yamaha F75 Manuel De L'utilisateur

Components
EMU26092

Main switch

The main switch controls the ignition system;
its operation is described below.
 "
" (off)
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
 "
" (on)
With the main switch in the "
the electrical circuits are on, and the key can-
not be removed.
 "
" (start)
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
OFF
30
" (off) posi-
" (on) position,
" (start) po-
" (on) position.
ON
START
ZMU01718
EMU26113

Steering friction adjuster

A friction device provides adjustable resis-
tance to the steering mechanism, and can be
set according to operator preference. An ad-
juster lever is located on the bottom of the til-
ler handle bracket.
To increase resistance, turn the lever to the
port side "A".
To decrease resistance, turn the lever to the
starboard side "B".
EWM00041
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
TIP:
 Check the tiller handle for smooth move-
ment when the lever is turned to the star-
board side "B".
 Do not apply lubricants such as grease to
the friction areas of the steering friction ad-
juster.
EMU26144
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
" (up) trims the