Yamaha F75 Manuel De L'utilisateur page 65

3. Place the throttle grip in the "
(start) position. After the engine starts,
return the throttle to the fully closed po-
sition.
4. Turn the main switch to "
and hold it for a maximum of 5 seconds.
5. Immediately after the engine starts, re-
lease the main switch and allow it to re-
" (on). NOTICE: Never turn
turn to "
the main switch to "
the engine is running. Do not keep the
starter motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 seconds,
the battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
aged. If the engine will not start after 5
seconds of cranking, return the main
switch to " " (on), wait 10 seconds,
then crank the engine again.
"
TIP:
 When the engine is cold, it needs to be
warmed up. For further information, see
page 61.
 If the engine is warm and fails to start, open
the throttle slightly and try to start the en-
gine again. If the engine still fails to start,
see page 89.
EMU2762B
Electric start and remote control models
EWM01842
 Failure to attach the engine shut-off
cord could result in a runaway boat if
operator is ejected. Attach the engine
" (start),
shut-off cord to a secure place on your
clothing, or your arm or leg while oper-
ating. Do not attach the cord to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
 Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power, the
boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1.
" (start) while
[ECM00193]
WARNING
Place the remote control lever in " "
(neutral).
N
Operation
ZMU01771
59