Warming Up Engine; Procedure For Warming Up Engine; Checks After Engine Warm Up; Shifting - Yamaha F75 Manuel De L'utilisateur

the cooling water inlet on the lower case
or the cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
EMU27671

Warming up engine

EMU41233

Procedure for warming up engine

1. After starting the engine, warm up the
engine until the engine speed stabilizes
at idle speed to provide maximum oper-
ating performance and acceleration.
NOTICE: Failure to do so will shorten
engine life.
[ECM04550]
2. Check that the low oil pressure-alert indi-
cator remains off. NOTICE: If the low oil
pressure-alert indicator blinks after
the engine starts, stop the engine.
Otherwise, serious engine damage
could occur. Consult your Yamaha
dealer.
[ECM02381]
EMU36532

Checks after engine warm up

EMU36542

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36981

Stop switches

 Turn the main switch to "
engine stop button and make sure the en-
gine stops.
 Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
 Confirm that the engine cannot be started
with the clip removed from the engine shut-
off switch.
EMU34491
Shifting
EWM00181
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01611
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the en-
gine, shift to neutral, then restart the en-
gine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
1. Neutral interlock trigger
Operation
", or press the
1
ZMU01727
61