Operation; Mode Of Operation - Meister MWS2200-230 Traduction Du Manuel D'utilisation Original

Place­the­clamping­flange­(10)­on­the­
spindle (9). Regardless of whether the
grinding­body­has­a­flat­or­deep­interi-
or,­the­clamping­flange­must­be­used.­
For this, follow Figure 2. Figure 2 also
shows­show­the­tensioning­flange­(10)­
is­to­be­fitted­when­using­thick­or­thin­
grinding discs.
Tighten­the­clamping­flange­(10)­firm-
ly. To do this, press the spindle lock
(13) and, at the same time, rotate the
clamping­flange­(10)­clockwise­using­the­
wrench (15).
CAUTION! Make sure that the
grinding body has been secured
well, but do not use force to do so!
This can result in a broken grinding
body!
Rotate the grinding body by hand. Make
sure that it is secured and rotates prop-
erly. The grinding body may not wobble.
CAUTION! Allow the grinding
body to cool down before replac­
ing it. Risk of burning! Always work
with the disc cover mounted!
8 – Operation
Switching on (Figure 6)
Grasp the device by the handle (2) and
additional­handle­(6)­and­hold­firmly.­Push­
the sliding safety switch (3) with the index
finger­in­the­direction­of­the­arrow­and­
press­the­On/Off­switch­(4)­in­the­direct­of­
the arrow using the entire hand.
Soft starting
The machine has soft start electronics to
gently start the motor without damaging
it. The highest revolutions required to
5455260-Winkelschleifer_man.indd 67 5455260-Winkelschleifer_man.indd 67
operate can be achieved after just a few
seconds.
Switching off
Release­the­On/Off­switching­mech-
anism (4) and allow the motor of the
device to come to a complete standstill.
CAUTION! Only set the power tool
down after it has come to a standstill.
Test run
CAUTION! Carry out a test run
prior to each use and after each
tool change! Always make sure that
the grinding bodies are in good work­
ing order, that they are correctly
mounted and rotate freely. The test run
should last for at least 1 minute.
9 – Mode of operation
•­ Always­place­the­workpiece­on­a­firm­
surface before starting.
•­ Observe­rotation­direction­and­function
•­ The­distance­between­the­user­and­
the machine should be as great as
possible.
•­ Avoid­jolting­the­workpiece.
CAUTION! Never machine mate­
rial containing asbestos.
Separating
Only exert low pressure and no lateral
loads on the separating disk. Adapt the
feed to the material and the revolutions.
Device must operate in counter-motion
(Figure 7) and be positioned at a 90°
angle to the workpiece.
67
24.07.20 11:03 24.07.20 11:03