Meister MWS2200-230 Traduction Du Manuel D'utilisation Original page 57

c Disconnect the plug from the power
source before making any adjust­
ments, changing accessories, or stor­
ing power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper­
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the­power­tool­for­operations­different­
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
b If the power cable of this device is
damaged, it must be replaced by the
5455260-Winkelschleifer_man.indd 57 5455260-Winkelschleifer_man.indd 57
manufacturer, their customer service
operation,­or­a­similarly­qualified­per-
son, in order to prevent risks.
II. Safety notes for all applications
Shared safety notes regarding sepa­
rating and grinding:
a This electrical tool is to be used
as a grinder and cutting device.
Pay attention to all of the warning
notes, instructions, diagrams and
data you receive with the unit. If
you do not observe the following
instructions, it may lead to electrical
shock,­fire­and/or­serious­injuries.
b This electrical tool is not suitable
for sandpaper sanding, working
with wire brushes, polishing. Uses
for which the tool is not designed
may cause risks and injury.
c Do not use accessories that have
not been designed and recommend­
ed by the manufacturer for use with
this electrical tool. Just because you
can­affix­an­accessory­to­your­electri-
cal tool, does not guarantee that it is
safe to use.
d The permitted revolutions of the
tool insert must be at least as high
as the highest revolutions specified
on the electrical tool. Accessories
that turn faster than is permitted may
be destroyed.
e The external diameter and thick­
ness of the tool insert must match
the dimensions of your electrical
tool. Incorrectly measured tool inserts
cannot be properly protected or
checked.
f Grinding disks and flange must fit
perfectly onto the grinding spindle
57
24.07.20 11:03 24.07.20 11:03