gers are inherent in the type and con-
struction of the device:
• Contactwiththeunprotectedgrinding
disc,
• Graspingastillrotatinggrindingdisc,
• Partsflyingoffofthegrindingdisc
and other parts,
• Damagetothehearingifthepre-
scribed ear defenders are not worn,
• Breathingindust,
If the instructions in your operating
instructions are not observed, incorrect
use may result in other residual risks.
5 – Technical information
Technical data
Power supply
Nominal
consumption
Spindle revolutions n 6600 min
Protection class
Disk size
Joining thread
Mains cable
Weight
Technical changes reserved.
Noise emission/vibration
Noise emission
L
: 95,2 dB(A), L
pA
Measuring inaccuracy:
K
: 3,0 dB(A), K
pA
64
5455260-Winkelschleifer_man.indd 64
5455260-Winkelschleifer_man.indd 64
230-240 V~/50 Hz
2200 W
-1
II
Ø 230 mm
M 14
300 cm
ca. 4,0 kg
: 106,2 dB(A)
WA
: 3,0 dB(A)
WA
Hand/arm vibrations
a
: 9,838 m/s
2
(main handle);
h,AG
Measuring inaccuracy K: 1,5 m/s
a
: 6,251 m/s
(additional handle);
2
h,AG
Measuring inaccuracy K: 1,5 m/s
Noise/vibration information
Measured values determined in accord-
ance with EN 60745-1, EN 60745-2-3.
Thespecifiedvibrationemissionvalue
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
T hespecifiedvibrationemissionvalue
can also be used for an introductory
evaluationoftheinfluence.
Information about minimising vibra
tions
Warning: The actual vibration
emission value present during
the use of the machine may deviate
from the specification given in the
operating instructions or determined
by the manufacturer. This may be
caused by the following influencing
factors that should be taken into
account prior to and during each use:
• Isthedevicebeingusedcorrectly
• Isthecorrecttypeofmaterialbeing
processed
• Isthedeviceinproperworkingorder
• A rethehandlesoroptionalvibration
handlesmountedandfixedsecurely
up against the body of the machine.
If your hands experience an unpleasant
sensation or the skin changes colour
2
2
24.07.20 11:03
24.07.20 11:03