Operation; Mode Of Operation; Maintenance And Environmental Protection - Meister MWS2400-230 Traduction Du Manuel D'utilisation Original

5455320-Winkelschl_man 08.05.15 13:49 Seite 61
8 – Operation
Switching on (fig. 7)
Grasp and hold the machine firmly by
the handle (2) and additional handle (12).
Push the safety slide switch (3a) in
arrow direction with the index finger and
press the On/Off switch (3b) in arrow
direction with the whole hand (fig. 7).
Soft start
The tool has an electronic soft-start
system to start-up the motor gently. The
maximum speed required for working is
reached within a matter of seconds.
Switching off (fig. 7)
Release the On switch (3) and hold the
machine until the motor has stopped
running.
Test run
CAUTION! Always carry out a test
run before starting work and after
every tool change!
Always ensure that the tools are in good
condition, correctly mounted and able to
turn freely. The trial run should last
approx. 30 sec.
9 – Mode of operation
• Always place the workpiece on a firm
surface before starting.
• Observe rotation direction and function
• The distance between the user and
the machine should be as great as
possible.
• Avoid jolting the workpiece.
CAUTION! Never machine
material containing asbestos.
Cutting
Mount the protective hood for cutting
discs (5) in accordance with Chapter 7,
and set as required.
Apply slight pressure to the cutting disk
from above, but NOT from the side.
Adjust forward pressure to material and
rotation speed. The machine must work
in reverse rotation (fig. 8).
CAUTION! Do not cut wet
material.
Roughing
Mount the protective hood for roughing
discs (15) in accordance with Chapter 7,
and set as required.
Hold the machine at an angle of 30°
to 40° to the workpiece. Move the
machine back and forward with
moderate pressure.
10 – Maintenance and
environmental
protection
CAUTION! Before any
maintenance working on
the appliance, unplug it from the
mains.
Remove dust regularly from machine
and ventilation slits. Clean the case only
with a damp cloth – Do not use
solvents. Then dry well.
61