Operation; Mode Of Operation; Maintenance And - Meister WS750-125M Traduction Du Manuel D'utilisation Original

Additional grip
The additional handle (6) can, depending
on the way in which you are working, be
mounted to two different positions on the
sanding head (fig. 4).
8 – Operation
Switching on (fig. 7)
Push the sliding switch in the direction
of the arrow to I (On). Allow to lock into
place for two-handed operations.
Switching of (fig. 7)
Release the sliding switch, if locked,
gently press the rear section of the slid-
ing switch. The switch will jump to 0
(Off). Only put the machine down after it
has come to a complete standstill.
Restart protection/power failure pro­
tection
In the event of a power failure, a under-
voltage relay is triggered. This prevents
the device being switched back on
automatically as soon as the power sup-
ply is restored. In order to switch the
device back on when the power supply
is restored, it must be switched off and
then back on at the On/Off switch.
Test run
CAUTION! Always carry out a test
run before starting work and after
every tool change!
Always ensure that the tools are in good
condition, correctly mounted and able to
turn freely. The trial run should last
approx. 30 sec.
62
5405130-Winkelschleifer-man.indd 62 5405130-Winkelschleifer-man.indd 62
9 – Mode of operation
• Always place the workpiece on a firm
surface before starting.
• Observe rotation direction and func-
tion
• The distance between the user and
the machine should be as great as
possible.
• Avoid jolting the workpiece.
CAUTION! Never machine material
containing asbestos.
Cutting
Apply slight pressure to the cutting disk
from above, but NOT from the
side. Adjust forward pressure to
material and rotation speed. The
machine must work in reverse rotation
(fig. 9).
CAUTION! Do not cut wet material.
Roughing
Hold the machine at an angle of 30° to 40°
to the workpiece. Move the machine
back and forward with moderate
pressure.
10 – Maintenance and envi­
ronmental protection
CAUTION! Before any mainte­
nance working on the appliance,
unplug it from the mains.
Remove dust regularly from machine and
ventilation slits. Clean the case only with
a damp cloth – Do not use solvents. Then
dry well.
27.10.20 12:18 27.10.20 12:18