Meister MWS2200-230 Traduction Du Manuel D'utilisation Original page 66

groove on the drive head (12). Assemble
in the reverse order.
Mounting the additional handle
Depending on the working method being
used, the additional handle (6) may be
mounted­to­three­different­positions­on­
the gear head (12) (Figure 4).
To do this, screw the additional handle,
using the thread, into one of the mount-
ing­points­(14).­Make­sure­that­it­is­firmly­
seated and check seating regularly
when using the power tool.
CAUTION! The device may only
be operated with two­hands
when the additional handle is mount­
ed.
Mounting the grinding tools
CAUTION! Pull the plug before
doing any work on the device!
Permitted grinding tools
The permitted revolutions (min
grinding disks must, at least, meet the
idle revolutions of the machine or be
labelled­with­a­specification­of­80­m/s­
circumferential speed. For this reason,
check the permitted revolutions or cir-
cumferential speed on the label of the
grinding disks.
Grinding disk dimensions:
•­ Ø:­230­mm­
•­ Thickness:­max.­6.4­mm­
•­ Drilled­mounting­hole:­22.23­mm
Separating disk dimensions
•­ Ø:­230­mm­
•­ Thickness:­max.­3.0­mm­
66
•­ Drilled­mounting­hole:­22.23­mm
5455260-Winkelschleifer_man.indd 66 5455260-Winkelschleifer_man.indd 66
Diamond separating disk dimensions:
•­ Ø:­230­mm­
•­ Thickness:­max.­3.0­mm­
•­ Drilled­mounting­hole:­22.23­mm
Only use grinding disks, separat­
ing disks and diamond separat­
ing disks as listed in the operating
instructions.
•­ Do­not­use­separating­disks­for­
roughing and deburring!
Separating and roughing discs
•­ Push­the­spindle­lock­(13)­and­rotate­
the spindle (9) until it engages
(Figure 5).
•­ Hold­the­spindle­lock­(13)­down­and­
insert the wrench (15) into the holes
on­the­tensioning­flange­(10).
•­ Rotate­the­wrench­anti­clockwise­to­
release­the­flange­(10)­(Figure­5).
•­ Remove­the­tensioning­flange­(10)­
-1 ) of the from the spindle Do not remove the
support­flange­(11).
•­ Check­whether­the­support­flange­(11)­
is seated correctly on the spindle. The
side with the ring joint (10a) must face
away from the power tool (Figure 2)
•­ Place­the­grinding­body­on­the­spin-
dle.
CAUTION! Check the grinding
body before placement for possi­
ble damages, e.g. cracks or wear!
Never use a damaged or worn grind­
ing body!
CAUTION! Pay attention to the
direction of rotation on the
grinding disc!
24.07.20 11:03 24.07.20 11:03