Operation; Mode Of Operation; Maintenance And Environmental Protection - Meister MWS900-125 Traduction Du Manuel D'utilisation Original

5455200-Winkelschl_man 08.05.15 13:07 Seite 59
8 – Operation
Switching on and off (fig. 7)
The machine has a two button security
switch mechanism (1): The machine can
only be put into operation if the handle is
held firmly and both buttons are pressed.
When the handle is released, the machine
switches off automatically to ensure that
accidental operation is not possible.
Test run
CAUTION! Always carry out a
test run before starting work and
after every tool change!
Always ensure that the tools are in good
condition, correctly mounted and able to
turn freely. The trial run should last
approx. 30 sec.
9 – Mode of operation
• Always place the workpiece on a firm
surface before starting.
• Observe rotation direction and function
• The distance between the user and
the machine should be as great as
possible.
• Avoid jolting the workpiece.
CAUTION! Never machine
material containing asbestos.
Cutting
Apply slight pressure to the cutting disk
from above, but NOT from the side.
Adjust forward pressure to material and
rotation speed. The machine must work
in reverse rotation (fig. 8).
CAUTION! Do not cut wet
material.
Roughing
Mount the protective hood for roughing
discs (12) in accordance with Chapter 7,
and set as required.
Hold the machine at an angle of 30° to
40° to the workpiece. Move the machine
back and forward with moderate pressure.
10 – Maintenance and
environmental
protection
CAUTION! Before any
maintenance working on the
appliance, unplug it from the mains.
Remove dust regularly from machine
and ventilation slits. Clean the case only
with a damp cloth – Do not use
solvents. Then dry well.
CAUTION! Conductive metallic
dust may impair the function of
the machine.
When working frequently with metals,
blow the ventilation slots out regularly
with compressed air and if necessary
install a safety cut-out switch (FI).
CAUTION! Electrical and battery
operated units that no longer work
should not be disposed of in the house -
hold waste! They are to be collected
separately, in accordance with the
2012/19/EU directive for
the disposal of electrical
and electronic waste, and
sent for proper and
environ mentally-friendly
recycling.
59