Miller PipeWorx Remote Feeder Interface w/Cable Manuel Du Propriétaire page 26

Table des Matières

Publicité

H44
H45
H46
H47
H48
H49
H60
H61
H62
H63
H64
H65
H66
H70
H98
H99
OM-239 982 Page 22
Motor Low Bus
Button Stuck Feeder
Trigger Stuck Left
Trigger Stuck Right
Trigger Fault Left
Trigger Fault Right
Memory Card Fault
File Read Error
File Write Error
Invalid File
Memory Card Locked
Read Only File
No Memory Card Detected
Weld Library
Serial Communication Loss
Serial Communication Malfunction
Indicates input primary line voltage is too low or power source
is incorrectly linked.
Increase primary line voltage to at least 90% of specified
nominal voltage.
If this code continues to appear on the display, contact the
nearest Factory Authorized Service Agent.
Indicates button is stuck on the feeder upon feeder power up.
Fault will clear when button is released.
Indicates left trigger stuck fault. Fault will clear when left trigger
is released.
Indicates right trigger stuck fault. Fault will clear when right
trigger is released.
Indicates left trigger was held too long in trigger jog (the lesser
of 60 seconds or 30 ft (9.1 m) of wire.
Indicates right trigger was held too long in trigger jog (the lesser
of 60 seconds or 30 ft (9.1 m) of wire.
Indicates unable to read memory card. Faulty memory card or
wrong format.
Indicates faulty file on memory card.
Indicates full or faulty memory card.
Indicates an invalid file on memory card. The system was able
to read the file; however, the contents of the file were invalid.
Remove card or press any button to clear error.
Indicates a save was attempted to a locked card. This refers to
the physical switch on the memory card. Unlock the memory
card and try again. Try a different memory card. Remove card
or press any button to clear error. If this code continues to ap-
pear on the display, contact the nearest Factory Authorized
Service Agent.
Indicates a save was attempted to a file that has been marked
read-only. Check with the appropriate person to see if the attrib-
utes are read only for a reason (the attributes can be altered
using a PC). Use a different card. Remove card or press any
button to clear error.
Indicates no memory card detected when a memory card oper-
ation was attempted. Insert a card or press any button to clear
error. Try a different memory card. If this code continues to
appear on the display, contact the nearest Factory Authorized
Service Agent.
Indicates missing/incomplete weld library in power source.
Weld library must be loaded from memory card.
Indicates serial communication was initially made and is now
malfunctioning. Check wire feeder/power source control cable
connection and tighten if necessary. May appear normally dur-
ing firmware updates. If this code continues to appear on the
display, contact the nearest Factory Authorized Service Agent.
Indicates serial communication is malfunctioning. Check wire
feeder/power source control cable connection and tighten if
necessary. May appear normally during firmware updates. If
this code continues to appear on the display, contact the
nearest Factory Authorized Service Agent.

Publicité

Table des Matières
loading

Table des Matières