Work Clamp; Ammeter And Voltmeter; Power Control Push Buttons And Pilot Light; Sequence Of Shielded Metal Arc Welding (Smaw) - Miller GPS-500 Mode D'emploi

4-3. Work Clamp

4-4. Ammeter And Voltmeter

4-5. Power Control Push Buttons And Pilot Light

4-6. Sequence Of Shielded Metal Arc Welding (SMAW)

Install &
Connect Connect MOG
Equipment
Turn On
Welding Power
Source
1
1
1
2
Install & Select
Electrode
System
Begin Welding
Tools Needed:
2
Put On
Personal Safety Set Controls
Equipment
1 Work Clamp
Use wire brush or sandpaper to
clean metal at weld joint area. Use
chipping hammer to remove slag
after welding.
Connect work clamp to a clean,
paint-free location on workpiece, as
close to weld area as possible.
sb4.1 5/92
1 Voltmeter
Voltmeter displays voltage at the
weld output terminals, but not nec-
essarily the welding arc due to
cable resistance, poor connec-
tions, etc.
2 Ammeter
Ammeter displays weld amperage
output of unit.
Ref. ST-059 546-G
1 Pilot Light
2 Power Control Push Buttons
Use buttons to turn unit, pilot light,
and fan motor ON and OFF.
Insert
Electrode
Into Holder
ssb7.1* 9/92
OM-266 Page 17