Troubleshooting guide
EN
Problem
Cause
Upper thread breaks
1.The machine is not threaded correctly.
2.The thread tension is too tight.
3.The thread is too thick for the needle.
4.The needle is not inserted correctly.
5.The thread is round wound the spool holder pin.
6.The needle is damaged.
Lower thread breaks
1.The bobbin case is not inserted correctly.
2.The bobbin case is threaded wrongly.
3.The lower thread tension is too tight.
Skipped stitches
1.The needle is not inserted correctly.
2.The needle is damaged.
3.The wrong size needle has been used.
4.The foot is not attached correctly.
Needle breaks
1.The needle is damaged.
2.The needle is not correctly inserted.
3.Wrong needle size for the fabric.
4.The wrong foot is attached.
Loose stitches
1.The machine is not correctly threaded.
2.The bobbin case is not correctly threaded.
3.Needle/ fabric/ thread combination is wrong.
4.Thread tension wrong.
Seams gather or pucker
1.The needle is too thick for the fabric.
2.The stitch length is wrongly adjusted.
3.The thread tension is too tight.
4.Fabric puckers.
Uneven stitches,
1.Poor quality thread.
uneven feed
2.The bobbin case is wrongly threaded.
3.Fabric has been pulled.
The machine is noisy
1.The machine must be lubricated.
2.Fluff or oil have collected on the hook or needle bar.
3.Poor quality oil has been used.
4.The needle is damaged.
The machine jams
Thread is caught in the hook.
Spool pin on the right position.
Correction
1.Rethread the machine.
2.Reduce the thread tension (lower number).
3.Select a larger needle.
4.Remove and reinsert the needle (flat side towards the back).
5.Remove the reel and wind thread onto reel.
6.Replace the needle.
1.Remove and reinsert the bobbin case and pull on the thread.
The thread should pull easily.
2.Check both bobbin and bobbin case.
3.Loosen lower thread tension as described.
1.Remove and reinsert needle (flat side towards the back).
2.Insert a new needle.
3.Choose a needle to suit the thread and fabric.
4.Check and attach correctly.
1.Insert a new needle.
2.Insert the needle correctly (flat side towards the back).
3.Choose a needle to suit the thread and fabric.
4.Select the correct foot.
1.Check the threading.
2.Thread the bobbin case as illustrated.
3.The needle size must suit the fabric and thread.
4.Correct the thread tension.
1.Select a finer needle.
2.Readjust the stitch length.
3.Loosen the thread tension.
4.Use a backing for fine or stretchy fabrics.
1.Select a better quality thread.
2. Remove bobbin case and retread and insert correctly.
3. Do not pull on the fabric while sewing, let it be taken up by the
machine.
1.Lubricate as described.
2.Clean the hook and feed dog as described.
3.Only use good quality sewing machine oil.
4.Replace the needle.
Remove the upper thread and bobbin case, turn the handwheel
backwards and forwards by hand and remove the thread remands.
Lubricate as described.
Press spool pin to the left postion.
102