Installation; Motor Preparation; Tube Preparation; Motor/Tube Assembly - SOMFY Roll Up 28 RTS Notice D'installation

3. INSTALLATION

3.1. Motor preparation

1) Fit the crown (a) and drive wheel (b)
to the motor.
2) Measure the length (L) between the
end of the drive wheel and the head
end.

3.2. Tube preparation

Cut the tube to the required length.
Deburr the tube and remove the debris.

3.3. Motor/tube assembly

1) Slide the motor into the tube.
Insert the wheel by aligning the wheel
to the tube profile. Insert the motor half
way and then slide the crown down the
motor and insert it in the tube. Finally,
push the motor inside the tube.
2) Not required, but if needed, fix the
tube to the motor with self-tapping
screws or steel pop rivets depending on
the dimension (L).
Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
1
2
1
2
a b
5